Skip to content
InjectBuddy
Skip to main content

How to Give a Subcutaneous Injection

Need your exact draw volume?

Open Calculator

Last updated:

A subcutaneous (SubQ) injection puts a small volume of liquid into the fatty layer just under the skin, using a short, fine needle. It is the route for insulin, GLP-1 medicines, most peptides and many other at-home injections. This guide covers the steps, where to inject and how to rotate sites, and the syringe and needle sizes used. Always follow the instructions on your product label and from the person who prescribed it; where they differ from anything below, they win.

Know your dose but not the units to draw? Convert it for a U-100 syringe first.

Open the syringe units to mL calculator →

What you need

  • The vial or pen, checked against the label: the right product, the right strength, and in date.
  • A new, sterile syringe and needle for every injection. Insulin syringes have the needle fixed on.
  • Alcohol swabs for the vial stopper and the skin.
  • A sharps container, or a rigid, puncture-proof container with a screw lid if you do not have one.
  • A way to record the dose and the site, such as a notebook or a dose log.

Step by step: drawing up the dose

  1. Wash your hands with soap and water and dry them. Work on a clean, dry surface.
  2. Check the vial. Read the name, strength (mg/mL) and expiry date. Look at the liquid: it should look the way the label describes. If a mixed vial has a discard date, check it has not passed.
  3. Wipe the rubber stopper with an alcohol swab and let it air-dry. Do not blow on it or wipe it dry.
  4. Pull air into the syringe equal to the dose you will draw, then push that air into the vial. This keeps the pressure even, so the liquid draws smoothly.
  5. Turn the vial upside down with the needle tip below the liquid, and pull the plunger back slowly past your dose mark.
  6. Remove air bubbles. Tap the barrel so bubbles rise, push them back into the vial, then set the plunger edge exactly on your dose line.
  7. Check the dose once more against the units or mL you worked out. See how to read an insulin syringe if the marks are new to you.
Worked example: units to mL

Your dose works out to 25 units on a U-100 syringe. Each unit is 0.01 mL, so 25 units is 25 ÷ 100 = 0.25 mL.

Worked example: matching the syringe to the dose

A dose of 0.12 mL is 12 units. A 0.3 mL (30-unit) syringe marked every unit is easier to read at 12 units than a 1 mL syringe marked every 2 units.

Step by step: giving the injection

  1. Choose the site using your rotation plan (below). Skip any spot that is scarred, bruised, tender, hard or broken.
  2. Clean the skin with an alcohol swab and let it dry fully, about 30 seconds.
  3. Pinch a fold of skin between thumb and finger if your instructions say so. With 4–6 mm needles, most adults do not need a pinch; with 8 mm or longer needles, or where there is little fatty tissue, a pinch helps keep the tip out of muscle.
  4. Insert the needle in one quick, smooth movement, at 90° (straight in) for short needles, or 45° if you have been told to use an angle.
  5. Push the plunger down steadily until the syringe is empty.
  6. Wait for a slow count of five to ten, then pull the needle out at the same angle it went in. Let go of the skin fold.
  7. Do not rub the site. If there is a drop of blood, press lightly with a clean cotton ball or gauze.
  8. Dispose of the syringe straight into the sharps container. Do not recap, bend or reuse needles.
  9. Record the time, dose and site, so the next injection goes somewhere else.
Needle angles for a subcutaneous injection: 90 degrees into a pinched fold, or 45 degrees where there is little fatty tissue 90° skin fatty (subcutaneous) layer muscle 45° skin fatty (subcutaneous) layer muscle
The needle tip should end in the fatty layer under the skin, not in muscle. Short needles go straight in at 90°; a 45° angle is used where there is little fatty tissue.

Where to inject

SubQ injections go where there is a layer of fatty tissue between skin and muscle. The usual areas are:

AreaWhere exactlyNotes
AbdomenBelow the ribs and above the hip bones, at least 5 cm (2 inches) from the navelLargest area and easy to reach and see
ThighsFront and outer side of the upper thigh, a hand's width below the hip and above the kneeEasy to reach when seated
Upper armsBack and outer side of the upper arm, between shoulder and elbowOften needs a second person to pinch the fold
Upper buttocksUpper outer area, above and to the side of the creaseHard to reach alone

Some product labels name only some of these areas. Use the areas your label lists.

Site rotation

Rotation means not putting two injections in the same spot in a row. Labels for insulin and GLP-1 medicines ask for it, and nursing guides teach it as a routine step.

  • Rotate within an area. Keep using one area (say the abdomen) and move around within it, rather than jumping between areas at random.
  • Use quarters. Split the abdomen into four quarters around the navel and use one quarter at a time, in the same order.
  • Space each injection about 2.5 cm (1 inch, roughly two finger-widths) from the last one.
  • Keep a record of the site for each dose. For detail on patterns and charts, see rotating injection sites.
Abdomen split into four quarters around the navel, used in order for site rotation 1 2 3 4 keep 5 cm clear of the navel
A simple rotation plan: work through the four quarters of the abdomen in order, moving about 2.5 cm (1 inch) from the last spot each time.
Worked example: daily injections in the abdomen

With four quarters and about seven spots in each, spaced 2.5 cm apart, you have 4 × 7 = 28 spots. Used in order, a daily injection returns to the same spot about every four weeks.

Worked example: weekly injections

A once-weekly injection rotated through the four abdomen quarters uses each quarter once every 4 weeks. Adding the thighs as two more areas makes it once every 6 weeks.

Worked example: twice-daily injections

Two injections a day is 14 a week. Using the abdomen in the morning and a thigh in the evening keeps each area to 7 injections a week.

SubQ or IM?

SubQ uses short needles (4–12.7 mm) into fat. Intramuscular (IM) injections use longer needles, usually 25–38 mm, into muscle, and are used for products such as testosterone oil. The route is set by the product label, not by preference. The IM vs SubQ injections guide compares the two.

Syringe and needle facts

Most SubQ doses measured from a vial use insulin syringes. They are marked in units: on a U-100 syringe, 100 units = 1 mL, so 1 unit = 0.01 mL.

SyringeHoldsUsual markingsSuits doses of
0.3 mL30 unitsEvery 1 unit (some every half unit)Up to 30 units
0.5 mL50 unitsEvery 1 unit30 to 50 units
1 mL100 unitsEvery 2 units50 to 100 units
Needle lengthIn inchesCommon use
4 mm5/32"Pen needles; 90° without a pinch for most adults
5–6 mm3/16–1/4"Short syringe and pen needles
8 mm5/16"Common insulin syringe needle; a pinch is often advised
12.7 mm1/2"Older standard length; pinch and angle as instructed

Gauge is the needle's thickness: the higher the number, the thinner the needle. SubQ needles are usually 29G to 32G. Insulin syringe needles are fixed, so the gauge and length are printed on the box. More on sizes in the insulin syringe sizes chart and in 0.3 mL vs 0.5 mL vs 1 mL syringes.

Worked example: 0.3 mL syringe

A 0.3 mL syringe holds 0.3 × 100 = 30 units. A 35-unit dose does not fit; use a 0.5 mL syringe.

Worked example: half-unit marks

On a 0.3 mL syringe with half-unit marks, each small line is 0.5 units = 0.005 mL.

Worked example: reading 1 mL syringe marks

On a 1 mL syringe marked every 2 units, a 15-unit dose sits halfway between the 14 and 16 lines. A 0.3 or 0.5 mL syringe marked every unit gives a line at 15.

Safe handling and disposal

  • Use each needle and syringe once. Never share needles, syringes or pens, even with a new needle.
  • Put used sharps straight into a sharps container. When it is about three-quarters full, close it and dispose of it the way your local council or pharmacy says.
  • Store vials as the label says. Many mixed vials go in the fridge at 2–8 °C; let a cold dose reach room temperature for a few minutes if your instructions allow.
  • Go through the full injection safety checklist before your first at-home injection.

Frequently asked questions

Do I need to pinch the skin for a SubQ injection?

With 4–6 mm needles, most adults can inject straight in at 90° without a pinch. With 8 mm or longer needles, or where there is little fatty tissue, a pinch is usually advised. Follow your own instructions.

What angle should a subcutaneous needle go in?

90° (straight in) for short needles, or 45° if you have been told to use an angle, for example where there is little fatty tissue.

How far apart should injection sites be?

About 2.5 cm (1 inch) from the last injection, and at least 5 cm (2 inches) from the navel when using the abdomen.

Can I reuse an insulin syringe?

No. Syringes and needles are single-use and sterile only until first use. Use a new one for each injection.

What size syringe do I need for a SubQ injection?

Pick the smallest syringe that holds your dose: 0.3 mL for up to 30 units, 0.5 mL for up to 50 units and 1 mL for up to 100 units on U-100 syringes.

Sources

  1. MedlinePlus (US National Library of Medicine). Subcutaneous (SQ) injections
  2. CDC. Injection safety: clinical guidance (2024)
  3. WHO. Best practices for injections and related procedures toolkit (2010)
  4. CDC. About injection safety (2024)

This guide is for general educational purposes only and does not constitute medical advice. Always follow your prescriber’s specific instructions and consult a qualified clinician before changing any protocol.

How these guides are prepared