Last updated: October 2026
Semaglutide Dosage Calculator — Units to mL
Quick answer: A 0.25 mg starting dose from a 5 mg/mL vial is 0.05 mL = 5 units on a U-100 syringe. Formula: Volume (mL) = Dose (mg) ÷ Concentration (mg/mL).
About this calculator
This page turns a semaglutide dose into a syringe draw. Semaglutide doses are small, from 0.25 mg at the first step to 2.4 mg at the top step, so the draws run from a few units to under 50 units. The tool works out Volume (mL) = Dose (mg) ÷ Concentration (mg/mL) for compounded vials of 2.5, 5 or 10 mg/mL, or any custom strength, and shows the U-100 reading beside it. It is built for vial and syringe use, not for branded pens. To check your BMI before or during GLP-1 treatment, use the BMI calculator.
How to use this calculator
Read the concentration off your pharmacy label in mg/mL, then enter the dose your prescriber gave you in mg. If you mixed the vial yourself from powder, the peptide calculator works out the concentration from the BAC water you added.
Pick a preset vial strength or type your own, then set the dose. The five usual semaglutide steps are 0.25, 0.5, 1.0, 1.7 and 2.4 mg, and the result shows mL and units together.
Precision matters most at 0.25 and 0.5 mg, where the draw is only 2.5 to 10 units. The tool assumes a U-100 syringe, where 1 unit = 0.01 mL. Read the barrel at eye level and compare it with the units shown here before you inject.
Worked examples in semaglutide units
Vial concentration: 2.5 mg/mL
Prescribed dose: 0.25 mg
Draw = 0.25 ÷ 2.5 = 0.10 mL = 10 units (U-100 syringe)
Vial concentration: 10 mg/mL
Prescribed dose: 0.25 mg
Draw = 0.25 ÷ 10 = 0.025 mL = 2.5 units, a half unit that is hard to read on a U-100 barrel
Vial concentration: 5 mg/mL
Prescribed dose: 0.5 mg
Draw = 0.5 ÷ 5 = 0.10 mL = 10 units (U-100 syringe)
Vial concentration: 5 mg/mL
Prescribed dose: 1.7 mg
Draw = 1.7 ÷ 5 = 0.34 mL = 34 units (U-100 syringe)
Vial concentration: 10 mg/mL
Prescribed dose: 2.4 mg
Draw = 2.4 ÷ 10 = 0.24 mL = 24 units (U-100 syringe)
Common dose reference table
| Dose | 2.5 mg/mL vial | 5 mg/mL vial | 10 mg/mL vial |
|---|---|---|---|
| 0.25 mg | 0.10 mL (10 U) | 0.05 mL (5 U) | 0.025 mL (2.5 U) |
| 0.5 mg | 0.20 mL (20 U) | 0.10 mL (10 U) | 0.05 mL (5 U) |
| 1.0 mg | 0.40 mL (40 U) | 0.20 mL (20 U) | 0.10 mL (10 U) |
| 1.7 mg | 0.68 mL (68 U) | 0.34 mL (34 U) | 0.17 mL (17 U) |
| 2.4 mg | 0.96 mL (96 U) | 0.48 mL (48 U) | 0.24 mL (24 U) |
Typical semaglutide titration schedule
Standard compounded vial protocol. Your prescriber sets your actual schedule — titration timing and doses vary. Full titration guide →
Typical schedule — your prescriber sets actual timing and doses.
| Step | Dose | Weeks | mg in 4 doses | Draw at 5 mg/mL |
|---|---|---|---|---|
| 1 | 0.25 mg | 1–4 | 1 mg | 0.05 mL (5 U) |
| 2 | 0.5 mg | 5–8 | 2 mg | 0.10 mL (10 U) |
| 3 | 1.0 mg | 9–12 | 4 mg | 0.20 mL (20 U) |
| 4 | 1.7 mg | 13–16 | 6.8 mg | 0.34 mL (34 U) |
| 5 | 2.4 mg | 17+ | 9.6 mg | 0.48 mL (48 U) |
The mg in 4 doses column shows how much of a vial one 4-week step uses. At 5 mg/mL a 1 mL vial holds 5 mg, so the first two steps together use 3 mg of it.
Vial strengths and pen equivalents
| Vial | Total | 0.25 mg doses | 0.5 mg doses | 1.0 mg doses | 2.4 mg doses |
|---|---|---|---|---|---|
| 5 mg/mL × 1 mL | 5 mg | 20 | 10 | 5 | 2 |
| 2.5 mg/mL × 2 mL | 5 mg | 20 | 10 | 5 | 2 |
| 10 mg/mL × 1 mL | 10 mg | 40 | 20 | 10 | 4 |
| 10 mg/mL × 2 mL | 20 mg | 80 | 40 | 20 | 8 |
Counts are whole doses from the labelled volume. Branded Wegovy pens work differently: the 0.25, 0.5 and 1 mg pens hold 0.5 mL and the 1.7 and 2.4 mg pens hold 0.75 mL, and the dose is dialled on the pen, so no draw is needed.
How semaglutide differs from tirzepatide
Both pages use the same formula and the same U-100 syringe, but the doses sit in different ranges. Semaglutide steps run from 0.25 to 2.4 mg, so a 10 mg/mL vial gives draws between 2.5 and 24 units and a 5 mg/mL vial gives 5 to 48 units. At those strengths no step reaches the 100 units of a 1 mL syringe.
Tirzepatide steps run from 2.5 to 15 mg, between six and ten times larger, so a 10 mg/mL vial gives draws of 25 to 150 units and the top two doses pass 100 units. Tirzepatide also rises in even 2.5 mg steps, while semaglutide uses uneven ones (0.25, 0.5, 1.0, 1.7, 2.4). If you use tirzepatide, open the Tirzepatide dose calculator.
Frequently asked questions
Dosing guide
Learn about dose escalation, injection preparation, and storage in the full reference guide. Semaglutide Dosing Guide →
Other calculators
Related guides
How this is calculated
This calculator divides your prescribed dose by the vial concentration to find the injection volume, then converts that volume to insulin-syringe units (volume in mL × 100 for a U-100 syringe). It is arithmetic only — nothing you enter is stored or sent anywhere, and the result is not medical advice. Always confirm your dose with your prescriber.
References
- WEGOVY (semaglutide) Prescribing Information — dosing & titration — FDA / DailyMed, 2021
- OZEMPIC (semaglutide) Prescribing Information — dosing & titration — FDA / DailyMed, 2017
- Once-Weekly Semaglutide in Adults with Overweight or Obesity (STEP 1) — N Engl J Med, 2021
- FDA Alert: Dosing Errors With Compounded Injectable Semaglutide Products — U.S. FDA, 2024
- Administration Errors of Compounded Semaglutide Reported to a Poison Control Center — Case Series — J Am Pharm Assoc, 2023
- Challenges With GLP-1 Agonist Initiation: A Case Series of Semaglutide Overdose Administration Errors — Clin Toxicol (Phila), 2024
- FDA Warns Consumers Not to Use Counterfeit Ozempic (semaglutide) Found in the U.S. Supply Chain — U.S. FDA, 2023
- FDA Concerns With Unapproved GLP-1 Drugs Used for Weight Loss — U.S. FDA
Citations are provided for transparency and education. They do not imply the cited authors or bodies endorse this tool. Always confirm dosing with your prescriber.